NBL1057-dat
Default Setup
- Default setup for BC-04B
And customize Setup
Jumper | BC-04B | EC-04B | HC-05 | HC-06 |
---|---|---|---|---|
JP1 | BC | BC | HC | HC |
JP2 | - | - | state or status * | state or status * |
JP3 | BC | BC | HC | HC |
JP4 | hardware Master or slave | hardware Master or slave | - | - |
JP5 | hardware or software mode | hardware or software mode | - | - |
- state or status: pair state or AT commands status
Base Board Pin Definitions
from left to right from front side
- GND
- +5V
- 3V3
- TXD
- RXD
- Clear - clear the pairing status
Backside Jumper Setup Mode:
Bottom jumper set hardware / software method for slave / master mode, Default setup for hardware method.
Jumper | Function | Mode | Default |
---|---|---|---|
SJ2 | master / slave | hardware control M/S mode | |
SJ1 | soft / hard Mode | control mode select | Hard |
- Top jumper set for slave / master mode.
- If you prefer to use software method by AT commands to change slave / mater mode, cut the bottom jumper connection (GND - middle pin), then re-connect to top by solder (VCC-middle pin).
SCH
Version New 2
- add extra two functions pad pins
Version Old 1
- R2 version add software and hardware master/slave mode select,
- default is software on.
- To use hardware select, need cut off connection on software ON with middle pin first.
base version
Wiring
- Board RXD -> target RXD, board TXD -> target TXD
Mode
- Be aware default setting of the product is slave mode, communication only available between master and slave mode, but not master and master, or slave and slave mode.
ref
-
based on module - NBL1018-dat - NBL1022-dat - NBL1057-dat
-
simialr modules - BC04-B-dat - HC05-dat - HC06-dat - NBL1012-dat