L76-dat

• https://www.quectel.com/product/gnss-l76-l/

The module can be connected to a dedicated passive or an active single-band GNSS antenna in order to track the GNSS satellite signals.

• Chip-cn-dat/quectel-dat/quectel-gps-dat/L76-dat/quectel_l76_series_hardware_design_v3-3.pdf

L76 VS L76-L VS L76-B

• L76-L supports: Additional LNA, I2C

block diagram

standby mode

Pulling STANDBY pin low will make the GNSS module enter Standby mode and releasing STANDBY pin which has been pulled high internally will make the modules back to Continuous mode. Note that pulling down STANDBY pin to ground will cause the extra current consumption which makes the typical Standby current reach to about 600 μA @ VCC=3.3 V.

Sending corresponding command will make the modules enter Standby mode. Sending any data via UART will make the modules exit standby mode as UART is still accessible in Standby mode.

chip map

ref

• antenna-dat - gps-dat

• L76