NBL1022-dat
https://www.electrodragon.com/product/lc-05-bluetooth-serial-moduel-masterslave-in-one/
Features:
- BQB certificated
- Master / Slave Mode supported
- classic bluetooth easy to use
SCH
Base Board Pin Definitions
from left to right from front side
- GND
- +5V
- 3V3
- TXD
- RXD
- Clear - clear the pairing status
Backside Jumper Setup Mode:
Bottom jumper set hardware / software method for slave / master mode, Default setup for hardware method.
Jumper | Function | Mode | Default |
---|---|---|---|
SJ2 | master / slave | hardware control M/S mode | |
SJ1 | soft / hard Mode | control mode select | Hard |
- Top jumper set for slave / master mode.
- If you prefer to use software method by AT commands to change slave / mater mode, cut the bottom jumper connection (GND - middle pin), then re-connect to top by solder (VCC-middle pin).
Note
Wiring
- Board RXD -> target RXD, board TXD -> target TXD
Mode
- Be aware default setting of the product is slave mode, communication only available between master and slave mode, but not master and master, or slave and slave mode.
Demo Video
ref
-
based on module - NBL1018-dat