MPC1119 DAT

First version please see here. MPC1073-dat

New features please see the right image

• Remove the right chip to free extra GPIOs
• Connect PIN4 or PIN8 to E_BUF for E-line
• Power input and output from the left large pin connectors

pin definitions

• pin definitions please refer to page - RMP-driver-dat

The following two GPIOs are not used at all and free:

• pin SC to raspberry pi pin ID_SC
• pin SD to raspberry pi pin ID_SD

Extra pins Used by Chain P3:

• to use the extra pins, you need to cut the jumpers to release them from the chip below, and chain P3 can not be used anymore.

Debug Port:

• RX	GND (some boards mark could be reversed): UART_RX debug, or ROW_E set to ground

Wiring

• If you supply power to matrix panels separately, the converter board MPC1119 will be power supplied by pins, no need extra power supply.
• If you supply all power from one port on the converted board, you can connect the power supply to matrix panels from another port.
• Voltage should be no more than 5.5V.

Extra Pins

• Please note there is a wrong typo on the board, IO12 should be IO14
• top pins: IO2 IO12 IO3
• bottom pins: IO21 IO26 IO16

Legacy Wiki

• RMP Guide - https://w.electrodragon.com/w/RPI_RMP_Guide#P3/P464x64(tested)

• MPC1073-DAT - MPC1119-DAT

E-line Setup, Extra GPIOs Pin Definitions

Setup E-line, PIN4 to E, PIN8 to GND or vice vese.

Chain-3 5V logic output pin definitions

3V3 direct lead pin definitions

ref

• MPC1119