BOM-DAT/mosfet-dat/2024-08-28-14-43-36.png
... ...
Binary files /dev/null and b/BOM-DAT/mosfet-dat/2024-08-28-14-43-36.png differ
BOM-DAT/mosfet-dat/2024-08-28-14-44-40.png
... ...
Binary files /dev/null and b/BOM-DAT/mosfet-dat/2024-08-28-14-44-40.png differ
BOM-DAT/mosfet-dat/mosfet-dat.md
... ...
@@ -23,6 +23,15 @@
23 23
| IRF8313 | | [[Infineon-dat]] |
24 24
25 25
26
+## high power mosfet
27
+
28
+![](2024-08-28-14-43-36.png)
29
+
30
+## Parallel using Mosfet for higher performance
31
+
32
+![](2024-08-28-14-44-40.png)
33
+
34
+
26 35
## ref
27 36
28 37
- [[mosfet]]
... ...
\ No newline at end of file
Board-dat/ITF/ITF1015-dat/ITF1015-dat.md
... ...
@@ -1,6 +1,8 @@
1 1
2 2
# ITF1015-dat
3 3
4
+- Note this board must stack with [[ITF1014-dat]] to use
5
+
4 6
## Board map
5 7
6 8
![](2024-08-28-14-37-22.png)
Tech-dat/Interface-dat/powerbus-dat/powerbus-dat.md
... ...
@@ -44,6 +44,12 @@ The communication port of the PowerBus main control board supports switching bet
44 44
45 45
The communication port of the PowerBus daughter board supports switching between TTL and 485, and adapts to the baud rate of the main control board. All wiring is plug-in design. It can provide 5V/12V/24V power supply for the slave station, with a maximum current of 500mA. It supports a maximum bus level of 40V and a maximum communication distance of 3000m. It has no special cable requirements and does not require any software protocol changes when connected to the original network. You can freely choose TTL or 485 to communicate with the original slave.
46 46
47
+## Note
48
+
49
+- TTL logic level at 3V3
50
+- baudrate commonly use 9600bps
51
+
52
+
47 53
48 54
## Slave board
49 55
... ...
@@ -57,5 +63,7 @@ The communication port of the PowerBus daughter board supports switching between
57 63
58 64
- https://www.facebook.com/Powerbus1/
59 65
66
+- [[mosfet-dat]]
67
+
60 68
- [[powerbus]]
61 69