3d23e2c33b4a0086e858069603f7cddd5fa94abe
Board/NBL/NBL1022-dat/NBL1022-dat.md
| ... | ... | @@ -19,3 +19,16 @@ Bottom jumper set hardware / software method for slave / master mode, Default se |
| 19 | 19 | |
| 20 | 20 | - Top jumper set for slave / master mode. |
| 21 | 21 | - If you prefer to use software method by AT commands to change slave / mater mode, cut the bottom jumper connection (GND - middle pin), then re-connect to top by solder (VCC-middle pin). |
| 22 | + |
|
| 23 | + |
|
| 24 | +## Note |
|
| 25 | + |
|
| 26 | +Wiring |
|
| 27 | + |
|
| 28 | +- Board RXD -> target RXD, board TXD -> target TXD |
|
| 29 | + |
|
| 30 | + |
|
| 31 | + |
|
| 32 | +## Demo Video |
|
| 33 | + |
|
| 34 | +- [Please see here.](https://www.youtube.com/watch?v=CmMGhHMciu8) |
|
| ... | ... | \ No newline at end of file |