Board/NWI/NWI1070-DAT/06-37-15-18-04-2023.png
... ...
Binary files /dev/null and b/Board/NWI/NWI1070-DAT/06-37-15-18-04-2023.png differ
Board/NWI/NWI1070-DAT/19-37-15-18-04-2023.png
... ...
Binary files /dev/null and b/Board/NWI/NWI1070-DAT/19-37-15-18-04-2023.png differ
Board/NWI/NWI1070-DAT/27-37-15-18-04-2023.png
... ...
Binary files /dev/null and b/Board/NWI/NWI1070-DAT/27-37-15-18-04-2023.png differ
Board/NWI/NWI1070-DAT/50-36-15-18-04-2023.png
... ...
Binary files /dev/null and b/Board/NWI/NWI1070-DAT/50-36-15-18-04-2023.png differ
Board/NWI/NWI1070-DAT/NWI1070-DAT.md
... ...
@@ -0,0 +1,41 @@
1
+
2
+
3
+# NWI1070-DAT
4
+
5
+### V2 Version
6
+
7
+- Add onboard LDO regualtor AMS1117, input voltage can be 5V
8
+- Add pull up and pull down control resistors for booting, pin 0, 2, EN, RST
9
+- tested working well for both ESP-01 or ESP-01S
10
+- Two booting control buttons, hold down IO button and press RST button to enter into flash mode.
11
+- Lead all pins 2*4 out to breadboard
12
+
13
+
14
+
15
+
16
+### V1 version
17
+
18
+#### Note:
19
+- This board is a kit, NOT soldered, you must soldered by yourself.
20
+- NOT include ESP-01 Board
21
+
22
+
23
+#### Features:
24
+
25
+- Lead all pins 2*4 out to breadboard
26
+- One group of pin to connect VCC with CHPD to enable the module, by jumper
27
+- One group of pin to connect RST with GND when you want to reset the module, by jumper
28
+- On board current capacitor 220UF
29
+- Only need a USB-TTL tool like CH340 breakout board to connect ESP-01: TX, RX, VCC, GND
30
+
31
+
32
+Please follow the soldering steps below to solder, otherwise the small board maybe a little difficult to do:
33
+
34
+
35
+![](50-36-15-18-04-2023.png)
36
+
37
+![](06-37-15-18-04-2023.png)
38
+
39
+![](19-37-15-18-04-2023.png)
40
+
41
+![](27-37-15-18-04-2023.png)
... ...
\ No newline at end of file