micropython dat
- https://github.com/Edragon/Code-MicroPython
- https://github.com/Edragon/STM32-F4-MicroPython2
- https://github.com/Edragon/STM32F4_MP-TPY
legacy wiki page - https://w.electrodragon.com/w/Micropython_Guide
About micropython:
Since the memory of STM32F401 is small, you need to install flash to simulate a USB flash drive. Recommended flash: W25Q32JVSSIQ 32MBit
The memory of STM32F411 is twice as large, so you don’t need an external flash to simulate a USB flash drive
Open the USB flash drive, edit the main.py file, click Save, and reset the MCU to execute the program.
Micropython Firmware / Bootloader
For STM32F405RGT
- Upload firmware hex by ST-link, no need reset pin
-
Flash Firmware - TPYBoardV102.hex
-
Reboot board and connect by USB, it will format itself, two LEDs ON, this takes 3-5 seconds
-
after this, U-disk will show up and sequential LED blink.
- Now can upload new sketch into it.
hardware flash size
Since the memory of STM32F401 is small, you need to install flash to simulate a USB flash drive. Recommended flash: W25Q32JVSSIQ 32MBit
The memory of STM32F411 is twice as large, so you don’t need an external flash to simulate a USB flash drive
Open the USB flash drive, edit the main.py file, click Save, reset the MCU and you can execute the program.