NWI1126-DAT

Pin Definitions

#define OM_LED 10 // on module led
#define WS_LED 9 // WS2812, select by jumper

#define addc 0

#define W_LED 4 // white
#define B_LED 5 // blue
#define G_LED 6 // green
#define R_LED 7 //red
  • IO9 button = program mode pin
  • EN button = reset pin
  • programmable LED pin 10

Wiring Diagram

Wiring for WS2812_5V

Jumpers

Jumper Name Option 1 Option 2 Function Note
JP_P 5V 6~28V board system power supply  
JP_L 5V 6~28V led strip power supply  
JP 8 (top) ws2812_dat Green reused pins for WRGB channels or WS2812  
JP 9 (bottom) ws2812_gnd Red reused pins for WRGB channels or WS2812  
back_jumper ws2812_dat_3.3V ws2812_dat_5V set ws2812 dat pin to 5V output default default
  • for 12V or 24V led strips, put JP_L red box's jumper on top position

  • back side jumper no need to change or check by default

  • Programming guide please refer to page USB-TTL-dat

Core Module Sch

Peripheral schamtic please refer to NWI1124-DAT

quick test

  • find demo code at https://github.com/Edragon/Arduino-ESP32
  • find your board IP address, verify it in browser: http://192.168.8.165
  • try the test commands to turn off on board prog LED: http://192.168.8.165/io/10/val/0
  • in which, IO is 10 and IO voltage level is 0

demo video

  • https://twitter.com/electro_phoenix/status/1610204098019880961

Note

  • ESP32-USB failed on code testing, may work or not, consider it is not working if you buy.

Update Log

  • New USB footprint to simplified the production process and reduce failure rate
  • Tested USB Functions working fine by customers feedback

ref

Table of Contents