NWI1124 DAT

• old wiki link: https://www.electrodragon.com/w/ESP_Light

Pin Definitions

Setup

Output Control Setup

based on above image, top pin 1 to bottom pin 5:

Set both RED box jumpers

• pin 4 to IO2 for WS2812 data
• pin 3 to GND
• you will get blue box setup (from pin3 to pin5) from top to bottom
• from top to bottom = WS2812_GND, WS2812_DAT, WS_2812_5V

Set both GREEN box jumpers:

• pin 4 to Green channel of RGBW
• pin 3 to Red channel of RGBW
• you will get white box setup (from pin1 to pin5) from top to bottom
• White / Blue / Red / Green / Voltage Supply

Setup Explantion V2

{width=50%}

{width=50%}

Power Supply Setup

{width=50%}

Green Box:

• Set the input power supply for board.
• choose 5V if input power is 5V, bypass the on board DC/DC converter
• Choose ~27V if input power is higher than 5V

Red Box:

• Set to ~27V for RGBW LED Strips
• Set to 5V for WS2812 LED Strips

Accessories

• Reserved pins for our RF-LINK EDRF2 module here. (one channel trigger IO0 Low)
• https://www.electrodragon.com/product/rf-switch-receiver-433315mhz-wdecoder/

Demos

• https://www.youtube.com/watch?v=_kBS72xQPqQ