NWI1124 DAT
General Info
- old wiki link: https://www.electrodragon.com/w/ESP_Light
Pin Definitions
Setup Explantion V2
Output Control Setup
based on above image, top pin 1 to bottom pin 5:
Set both RED box jumpers
- pin 4 to IO2 for WS2812 data
- pin 3 to GND
- you will get blue box setup (from pin3 to pin5) from top to bottom
- from top to bottom = WS2812_GND, WS2812_DAT, WS_2812_5V
Set both GREEN box jumpers:
- pin 4 to Green channel of RGBW
- pin 3 to Red channel of RGBW
- you will get white box setup (from pin1 to pin5) from top to bottom
- White / Blue / Red / Green / Voltage Supply
Power Supply Setup
Green Box:
- Set the input power supply for board.
- choose 5V if input power is 5V, bypass the on board DC/DC converter
- Choose ~27V if input power is higher than 5V
Red Box:
- Set to ~27V for RGBW LED Strips
- Set to 5V for WS2812 LED Strips
Accessories
- Reserved pins for our RF-LINK EDRF2 module here. (one channel trigger IO0 Low)
- https://www.electrodragon.com/product/rf-switch-receiver-433315mhz-wdecoder/
Demos
- https://www.youtube.com/watch?v=_kBS72xQPqQ