NWL1065-dat
Config Steps
- two red led on top, two green leds on bottom
- Long press and release to enter into next config
- Modules can communicate when the channel is same, even baudrate is different
Step | Action (short press) | Indication |
---|---|---|
1. Enter into Config | HOLD button and power up | all leds blink in turn |
2. config baudrate | switch baudrate | see image on the right |
3. Set wireless channel | choose channel | LED indicate 16 channels, including all leds off status |
4. Mode set | switch in three modes | see image on the right |
5. Confirm | - | long press until led blink in turns, and release LED will remain for 2 secs and done |
Config setup
ref
-
legacy wiki page - https://w.electrodragon.com/w/2.4G_Zigbee_CC2530_Module