MPC1073-test-log-dat.md

P8 P10 Outdoor 32x16 == tested = OK

Run example for our selling 32x16 panel

P10 - 32x16

./examples-api-use/demo -D 0 --led-cols=32 --led-rows=16 --led-multiplexing=8

./examples-api-use/demo -D 0 --led-cols=32 --led-rows=16 --led-multiplexing=3
./examples-api-use/runtext16.ppm -D 0 --led-cols=32 --led-rows=16 --led-multiplexing=8
./examples-api-use/demo -D 0 --led-cols=32 --led-rows=32 --led-multiplexing=1

To chain other panel:

--led-chain=2 to --led-chain=4

Other example will have the same configuration

--led-rows=8 --led-chain=2

32x32

multiplexing =1

./examples-api-use/demo -D 0 --led-cols=32 --led-rows=32 --led-multiplexing=1

P4 64x32 == tested

Tested panel is 64x32 P4-256x128-2121-A1, multiplexing=0

./examples-api-use/demo -D 0 --led-cols=64 --led-rows=32 --led-multiplexing=0

P3/P4 64x64 == tested

Extra Setup Needed

• Setup P4 jumper to ground, P8 jumper to #E line - MPC1073-multiplexing-dat

• multiplexing usually 0 or 1, try further options only when you have special board CMD for both P3/P4

commands

./examples-api-use/demo -D 0 --led-cols=64 --led-rows=64 --led-multiplexing=1

128x128 / 256x128 == X

• Not tested yet, should be not supported

more demos

cmd

./demo -D 1 runtext.ppm --led-no-hardware-pulse --led-slowdown-gpio=4 --led-cols=64 --led-rows=32

panel info (obseleted part)

Working Panel	Panel Specification	Command
32x16 P8 or P10	1/4	./demo -D 0 –led-rows=8 –led-chain=2
32x32 P6	1/8
64x32 P4	1/16
64x64 P4	1/32