IDD1002-dat
- legacy wiki page - https://w.electrodragon.com/w/Category:LED_Drive
Board Layout
CC Current calculation
output | R1 | R2 | R3 | R4 | output current |
---|---|---|---|---|---|
0.142241 ohm | 0.5R | 0.5R | 0.33R | nc | 700 mA |
Breakout board support up to
- 1W, 10W, 30W high power LEDs in our store
- also can shortly or not fully power 50W or 100W LEDs. 33V for 100W LEDs can work but not recommdedded for long term.
- Tested 5 Meters LED white strips.
- Pin Definition:
- IN +: Positive power supply IN-: Power supply negative.
- LED +: Connect the LED’s anode LED-: Connect the LED’s cathode
- PWM: Light Strengh control: dimming control signal (2.8V-6V turn on)
- PWM signal limit frequency: 20HZ-20KHZ, recommendations: 1KHZ or so
-
Each purchase is for 2 pieces boards.
- read more information on this page PT4115-dat